Picture Information:
Foam computer..FINALY DONE!!!

Picture Information:
Nice back ports dude...just took this pic today.. shows back ports..duh

Picture Information:
here u can see it all exposed. in order from bottom. apple ][ rack for monitor, metal sheet from home depot, use, unknown, pizza box housing motherboard, motherboard atrtached with standard plastic standoffs throuhg holes in bottom of pizza box. then u see teh cardboard manifold directing air over the cpu, and the top cardboar manifold , forcing air over a heatsink which is mounted in the hole on the top as seen below.

Picture Information:
here u can see inside the top manifold, and the side. air flows from left to front and left to top, the exits throuhg powersuply

Picture Information:
another nice shot from above

Picture Information:
here u can see the heatsink kinda.. its a 5x 7 heatsink with 1/2 in fins.. verry nice, verry big, aluminum

Picture Information:
a bomb? NO the LED aray of course.. are you dumb? sheesh.. ;) all leds are wired in parallel to eachother, and the black box thing with the funworld token inter the tape is the wirewound resistors.

Picture Information:
here u can see the heatsink i mounted cause it was kinda warm, even though rated at 5 watts each... im paranoid ;) they are 2 10s and a 50 ohm resistor in series to the leds, on the power side... i think on the 12 v line, but i dont quite rember what one i hooked it up to.... also ther is a green card, visible in the above pics, it is just basicly a solder point for the various fan(6) in this hulk.

Picture Information:
this is the top, , ther are 2 hard drives, the seagate and the Western digital

Picture Information:
TaDa.. the Wrong FOam!!! these were pics i had of the whita nasty musy foam i had, with just a little yellow on it after.. ... plus the leds never did work properly.. ium gona hack it apart and relocate all the leds ect.. and the thing thats drawn shows airflow.